CD2-300+2

4 top heads molding sander

This sander Moulding sander is build with 4 top heads and 1 right and 1 left head, QuickWood can build you any combination of heads that you might want. This style with 4 top heads are very popular for sanding white wood, right after the moulder at high speed. The extra 2 heads on top makes the sander capable of sanding mouldings at up to 100 feet per minute. Also the extra top sanders comes in handy with custom jobs where the quality and the sand as to be a little better than just average.

molding sander

Getting a little more in your molding sander

So the principal is that the more sanding heads you have the more sanding you can do at a faster feed speed. So with 4 top heads on this molding sander you could setup the machine with 2 heads of p120 grit and 2 heads of p150 grit for a coarse and fine sanding on your moldings if that is what is needed. The other solution would to have two heads with p150 grit and two heads with p180 grit to give the moldings a finer sand right before stain. It could also be you wanted to match up what you where doing on your doors to get the stain color right. With the 4 head molding sander there are a lot more possibilities.

Changing abrasives on your molding sander

The QuickWood molding sanders are normally setup with our Quick Strip abrasives and brush system, making the change of abrasives very easy and very cost effective. A normal shop would run this molding sander 3-4 hours per day and change out the paper every 3 to 4 month. When changing out the sandpaper just slide the sandpaper out of every brush (28 brushes per spindle). Changing abrasives on a molding sander like this takes about 20 min.


MetalFinish Trade Shows

September 30, 2009
by: admin • deburring metal

MetalFinish – Working on your edge

September 30, 2009
by: admin • deburring metal

Deburring Machines

September 28, 2009
by: admin • deburring metal

Deburring brush

September 28, 2009
by: admin • deburring metal